Yamaha YST-SW015 - Manual (Page 8)

E- 4
SPLIT SUBWOOFER
SUBWOOFER
( LOW PASS)
INPUT
/MONO
OFF LOW HIGH
AUTO STANDBY NORM REV
PHASE
POWER ON
OFF
110V–120V 220V–240V VOLTAGE
SELECTOR
INPUT
/MONO
OFF LOW HIGH
AUTO
STANDBY
NORM REV
PHASE
Notes
● Some amplifiers have line output terminals labeled PRE
OUT. When you connect the subwoofer to the PRE OUT
terminals of the amplifier, make sure that the amplifier
has at least two sets of PRE OUT terminals. If the
amplifier has only one set of PRE OUT terminals, do not
connect the subwoofer to the PRE OUT terminals.
● When connecting to a monaural line output terminal of
the amplifier, connect the L/MONO INPUT terminal.
CONNECTIONS
Caution: Plug in the subwoofer and other audio/video components after all connections are
completed.
Subwoofer
Amplifier
● To connect with a YAMAHA DSP amplifier (or AV
receiver), connect the SUBWOOFER (or LOW PASS etc.)
terminal on the rear of the DSP amplifier (or AV receiver)
to the L/MONO INPUT terminal of the subwoofer.
Connect the subwoofer to the line output (pin jack) terminal(s) of the amplifier.
● When connecting the subwoofer to the SPLIT
SUBWOOFER terminals on the rear of the DSP amplifier,
be sure to connect the L/MONO INPUT terminal to the
“L” side and the R INPUT terminal to the “R” side of the
SPLIT SUBWOOFER terminals.
Audio pin cable
(not included)
Left main speaker Right main speaker
To AC outlet
Subwoofer cable
(not included)
SW015(UB) (02.11.5)a 02.11.5, 3:13 PM 4