Zanussi ZKG6010 - Manual (Page 30)

30
Moving your appliance
•
You may damage some soft or badly fitted
floor coverings when you move the
appliance. The floor covering under the
appliance should be securely fixed so it does
not ruck up when you move the appliance
across it. Alternatively you could remove the
floor covering. This appliance is heavy and
care must be taken when moving it. Do not
try to move the appliance by pulling the door
handles.
•
To move the appliance, open the grill door.
Raise the appliance off its front feet by lifting
it from inside the oven. Pull the appliance
forward. When you replace the appliance
push it back to the stop and make sure there
is the same gap at each rear corner.
For your safety
•
Do not try to disconnect the appliance from
the gas supply if the supply pipe does not
have a bayonet connection, as described in
the installation instructions. If this is the case
contact the person who installed the
appliance.
Location of appliance
•
This appliance must not be installed in a
bed-sitting room of volume less than 20m
3 or
in a bathroom, shower room or garage. It is
essential that the appliance is positioned as
shown.
•
Shelves, wall cabinets and cooker hoods
must be fitted a minimum of 650mm directly
above the top of the hob (or greater for
cooker hoods if recommended by
manufacturers instructions) and 400mm
above the hob when fitted in line with the
outside of the appliance. If the units are
intended to be fitted adjacent to the
appliance but
less than
400mm
above the
hob, then a
minimum
space of
50mm must
be
maintained
between the
sides of the
unit and the
appliance.