Zanussi TCE7227W - Manual (Page 8)

8
Operating Sequence
Before using your tumble dryer for the first time, we
recommend to place a few damp cloths inside the
appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door (see picture).
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does not
get caught between the door and filter.
5. Select the drying programme or time. The lights
, and come on. The light of the
“START/PAUSE” button flashes and the
display shows the duration of the programme.
6. If required, press the low temperature button
and/or the “Buzzer OFF” button or the “Quick
drying” button .
7. Press the “START/PAUSE” button the
corresponding light stops flashing and drying
starts.
Only the light remains lit. If you have selected
the delayed start, the machine begins its
countdown.
If the programme selector dial is turned to another
position, when the machine is running, the buzzer
will sound, the programme phase indicator lights
will flash.
The drum turns alternately in both directions
during drying.
P1108 P1149
All drying programmes end with a 10 minute
cooling phase light
is on).
You may remove the laundry after this phase.
The lights , and illuminate.
8. If the laundry is not removed at the end of the
cycle, the dryer performs an anti-creasing phase
(duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will stop
automatically at the end of the anti-creasing phase.
Lights
, and remain lit and the buzzer
sounds every 10 seconds for 2 minutes.
The light of the “START/PAUSE” button goes
off and a flashing zero appears on the display.
9. Turn the programme selector dial to “0”; all the
lights go out. The appliance is switched off.
Remove the laundry.
If you open and then close the door before
turning the selector dial to “0” all the lights
corresponding to the phases making up the
performed programme come on and the
display shows the duration of the programme.
After each use
• Clean the filters (see page 10).
• Empty the water reservoir (see page 11).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position
and wait until
the end of this cooling phase before removing the
laundry. This will avoid a build-up of heat inside the
appliance.To do this first turn the dial to “0” and then
to
and depress “START/PAUSE” button.
Modifying the programme
To change a programme which is running, first cancel
it by turning the programme selector dial to “0”.
Select the new programme and press the
“START/PAUSE” button.
916096121.qxp 2006-06-02 13:28 Page 8