Zanussi ZKT 641 H - Manual (Page 8)

8
Using the automatic warm-up function
All cooking zones are equpped with an automatic
warm up function When setting a heat setting using
, when starting from
¾
, the cooking zone switches
to full power for a certain amount of time and then
automatically switches back to the heat setting set.
3
If during the automatic warm up
a
a higher
heat setting is selected, e.g. from
Á
to
Ã
, the
automatic warm up is adjusted.
3
If there is still residual heat on the cooking
zone (display
h
), the automatic warm up is
not performed.
The length of time that the automatic warm up func-
tion operates depends on the heat setting selected.
Locking/unlocking the control panel
The control panel, with the exception of the “On/Off”
sensor field, can be locked at any time in order to
prevent the settings being changed e.g. by wiping
over the panel with a cloth.
3
When you switch the appliance off, the locking
function is automatically switched off.
Control panel possible heat set-
tings Display
Switch on
(only when starting at
¾
)
Touch
¿
to
Æ a
(after 5 seconds)
Switch off Touch
Æ
to
¿
/
u Æ
to
u
Not used Touch
Ç
to
u Ç
to
u
Heat
setting Length of the automatic warm
up [min:sec] Intermediate
heat setting Length of the automatic warm
up [min:sec]
v 0:30
1 1:00
2 1:40 2. 2:40
3 4:50 3. 5:30
4 6:30 4. 8:10
5 10:10 5. 12:20
6 2:00 6. 2:30
7 3:30
8 4:30
9 ---
Control panel Display
Switch on Touch
l
(for 5 seconds)
Switch off Touch previously set heat setting