Yamaha YST-SW320 - Manual (Page 11)

English
E-
7
BASS
MUSIC NORM MOVIE REV HIGH LOW OFF
PHASE AUTO STANDBY
ON
POWER
OFF
VOLTAGE
SELECTOR
BASS
MUSIC NORM MOVIE REV HIGH LOW OFF
PHASE AUTO STANDBY
ON
POWER
OFF
VOLTAGE
SELECTOR
OUTPUT TO SPEAKERS
INPUT 1 INPUT 2 FROM AMPLIFIER
OUTPUT TO SPEAKERS
INPUT 1 INPUT 2 FROM AMPLIFIER
OUTPUT
TO SPEAKERS
INPUT
1
INPUT
2
FROM AMPLIFIER
OUTPUT
TO SPEAKERS
INPUT
1
INPUT
2
FROM AMPLIFIER
/MONO
/MONO
/MONO
/MONO
Ⅵ
Using two subwoofers
Connect the speaker output terminals of the amplifier to the INPUT1 terminals of the subwoofer, and connect the OUTPUT
terminals of the subwoofer to the main speakers.
Left main speaker Right main speaker
Subwoofer
Speaker output
terminals
To AC outlet
Subwoofer
To AC outlet
Amplifier
For connections, keep the speaker cords as short as
possible. Do not bundle or roll up the excess part of the
cords. If the connections are faulty, no sound will be heard
from the subwoofer or the speakers, or both of them. Make
sure that the + and – polarity markings of the speaker cords
are observed and set correctly. If these cords are reversed,
the sound will be unnatural and lack bass.
How to Connect:
Red: positive (+)
Black: negative (–)
1 Loosen the knob.
2 Insert the bare wire.
[Remove approx.
10 mm (3/8”)
insulation from the
speaker wires.]
3 Tighten the knob
and secure the wire.
Caution
Do not let the bare speaker wires touch each other as
this could damage the subwoofer or the amplifier, or
both of them.
< U.S.A., Canada, Australia, China and General models
only >
Banana Plug connections are also possible.
1 Tighten the terminal knob.
2 Simply insert the Banana Plug connector into the
terminal.
Connecting to the INPUT1/OUTPUT terminals of the subwoofer
1
2
3
1
2