Zanussi ZDC 5350 W - Manual (Page 17)

17
Adjusting the level of conductivity
Water contains, a variable quantity of limestone and
mineral salts of which quantities vary according to
geographical locations thus varying its conductivity
values.
Relevant variations of the conductivity of the water
compared to those prefixed by the factory could
slightly influence the residual humidity of the
laundry at the end of the cycle.
Your dryer allows you to regulate the sensitivity of
the drying sensor based on conductivity values of the
water by using the following procedure.
Procedure:
Turn the programme selector dial to switch on the
appliance
In selection mode press simultaneously the buttons 3
and 6 until « C0 » appears on the digits.
Adjusting the level of
conductivity:
Press button 5 sequentially: the level of conductivity
is indicated by the lighting of the horizontal hyphens.
6 3 2 4 5
Start/
Pause
No
Buzzer
Delay
Start
Clogged
Condenser
Drying
Cooling
End
Clogged Filters
Full Tank Quick
Dry
Low
Temperature
6 3 1 2 4 5
PROGRAMME
COTTON Extra dry
Ready to wear
Iron dry
Slightly damp
Store dry
Wring dry
Store dry Extra dry Iron dry
EXTRA PROGRAMME
Start/ Pause No Buzzer Door Delay Start
Clogged Condenser
Drying
Cooling
End
Clogged Filters
Full Tank
RESET/ OFF
Quick Dry Low Temperature
60 min
Cooling
SYNTHETIC
Easy iron
90 min
30 min TIMED PROGRAMME
Baby dry
FUNCTION ZDC 5350W
1.25
Normally, the appliance is factory-set to the
highest level; however, certain models may be
configured differently.
Memorising the new
setting:
Simultaneously press down buttons 3 and 6 until the
previous drying cycle time appears again on the
display and the buzzer sounds.
Display Conductivity degree
Approximative value
ºdH
C C 0 0 Low < 14
C C 0 0 Medium 15 - 21
C C 0 0 High > 21
125992691.qxd 26/05/2004 11:13 Pagina 17