Connections – Yamaha YST-SW325 User Manual

Page 8

Choose one of the following two connecting methods that is more suitable for your audio system.

Choose

(pages 4-5) if your amplifier has line output (pin jack) terminal(s)

Choose

(pages 6-7) if your amplifier has no line output (pin jack) terminal

Caution: Do not connect the power cord of the subwoofer and other components into an AC
outlet until all connections between components are completed.

Note

All connections must be correct, that is to say L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. Also, refer to the
owner’s manual of your component to be connected to the subwoofer.

• To connect with an amplifier (or AV receiver), connect the SUBWOOFER (or LOW PASS etc.) terminal on the rear of

the amplifier (or AV receiver) to the

/MONO INPUT2 terminal of the subwoofer.

• When connecting the subwoofer to the SPLIT SUBWOOFER terminals on the rear of the amplifier, be sure to connect

the

/MONO INPUT2 terminal to the “L” side and the

INPUT2 terminal to the “R” side of the SPLIT

SUBWOOFER terminals.

Notes
• Some amplifiers have line output terminals labeled PRE OUT. When you connect the subwoofer to the PRE OUT

terminals of the amplifier, make sure that the amplifier has at least two sets of PRE OUT terminals. If the amplifier has
only one set of PRE OUT terminals, do not connect the subwoofer to the PRE OUT terminals. Instead, connect the
subwoofer to the speaker output terminals of the amplifier. (Refer to pages 6-7.)

• When connecting to a monaural line output terminal of the amplifier, connect the

/MONO INPUT2 terminal.

• When connecting to line output terminals of the amplifier, other speakers should not be connected to the OUTPUT

terminals on the rear panel of the subwoofer. If connected, they will not produce sound.

CONNECTIONS

Connecting to line output (pin jack) terminals of the amplifier