Yamaha RX-V1200 - Manual (Page 58)

54
SET MENU
L R G S M L N O N E
1A CENTER SP
L A R G E S M A L L
1B MAIN SP
L R G S M L N O N E
1C REAR L/R SP
L R G S M L N O N E
1C REAR L/R SP
L R G S M L N O N E
1C REAR L/R SP
L A R G E S M A L L
1B MAIN SP
NONE
Select this if you do not have a center speaker. All of the
center channel signal are directed to the left and right
main speakers.
■ 1B MAIN SP (main speaker mode)
The OSD shows large or small main speakers depending
on how you set this item.
Choices: LARGE, SMALL
Initial setting: LARGE
LARGE
Select this if you have large main speakers. The entire
range of the left and right main channel signal is directed
to the left and right main speakers.
SMALL
Select this if you have small main speakers. The low-
frequency signals (90 Hz and below) of the main channel
are directed to the speakers selected with “1E LFE/BASS
OUT”.
Note
• When you select MAIN for “1E LFE/BASS OUT”, the low-
frequency signals (90 Hz and below) of the main channel are
directed to the main speakers even if you select SMALL for the
main speaker mode.
■ 1C REAR L/R SP (rear speaker
mode)
The OSD shows large, small or no rear speakers
depending on how you set this item.
Choices: LRG (large), SML (small), NONE
Initial setting: LRG
LRG
Select this if you have large left and right rear speakers or
if a rear subwoofer is connected to the rear speakers. The
entire range of the rear channel signal is directed to the
left and right rear speakers.
SML
Select this if you have small left and right rear speakers.
The low-frequency signals (90 Hz and below) of the rear
channel are directed to the speakers selected with “1E
LFE/BASS OUT”.
NONE
Select this if you do not have rear speakers.
y
• This unit is set in the virtual CINEMA DSP mode by selecting
NONE for “1C REAR L/R SP”.
0109V1200_52-64_EN(UA) 01.7.6, 9:30 AM 54