beautypg.com

If something does not work – Zanussi ZCF 410 User Manual

Page 9

background image

9

If you are still unable to solve the problem, summon the

assistance of authorised service staff.
Do not take any other steps. Incorrect procedure may

cause personal injury or lead to additional defects.
It is quite normal for the freezer to seem warm on the

outside occasionally, owing to the heat generated by the

freezing process. This heat also helps to prevent the

formation of moisture on the outside of the appliance which

could cause rust.
If the freezer has been switched off briefly, the compressor

may not start immediately when the current is re-

connected. This is quite normal.

IIN

N TTH

HEE C

CA

ASSEE O

OFF A

A PPO

OW

WEER

R FFA

AIILLU

UR

REE O

OR

R

B

BR

REEA

AKKD

DO

OW

WN

N

The hold-over period mentioned in the "Technical

Specification" section of this book refers to an estimated

time the freezer temperature will take to rise to an

unacceptable level for keeping frozen foods.
Providing the period of power failure or breakdown does not

exceed the hold-over period there will be no risk of damage

to the frozen food, providing you do not open the lid during

this period.
If the freezer is only half full or the lid is opened this will

reduce the hold-over time.
After the breakdown period you are recommended to

check the condition of food to ensure it has not started to

thaw. Frozen food must NOT be re-frozen once it has

thawed out. The following guidelines should assist you.
IIccee ccrreeaamm::

Once thawed should be discarded.

FFrruuiittss && VVeeggeettaabblleess:: If soft should be cooked and used up.
BBrreeaaddss && CCaakkeess::

Can be re-frozen without danger.

SShheellllffiisshh::

Should be refrigerated and used up quickly.

CCooookkeedd DDiisshheess::

ie. casseroles should be refrigerated

and used up.

SSmmaallll JJooiinnttss::

Should be cooked and can then be re-frozen

as cooked dishes.

CChhiicckkeenn::

Should also be cooked and re-frozen as a

cooked dish.

H

HO

OW

W TTO

O C

CH

HA

AN

NG

GEE TTH

HEE B

BU

ULLB

B

Before changing the bulb, isolate the appliance from the

electricity supply.
Unscrew the bulb, and replace it with a new bulb (max.

15W). Then reconnect the electricity supply.
Extra bulbs are available from your local Zanussi Service

Force Centre.

IF SOMETHING DOES NOT WORK

IIFF YYO

OU

UR

R FFR

REEEEZZEER

R D

DO

OEESS N

NO

OTT FFU

UN

NC

CTTIIO

ON

N SSA

ATTIISSFFA

AC

CTTO

OR

RIILLYY

Check the following before calling for service staff:

D

Deeffeecctt::

C

Chheecckk iiff::

PPoossssiibbllee ccaauussee::

AAccttiioonn::

Freezer not cold

Green light not on

Plug not connected correctly

Check plug and socket

Defect in switch or fuse

Check fuse, call electrician

Power failure

Wait until current returns

Green and red light on

Fresh food recently placed in freezer

Wait a couple of hours

Lid open too long

Wait a couple of hours

Green light on,

Thermostat set too warm

Set thermostat colder

red light not on

Lot of frost and ice formed

Defrost freezer

Freezer too cold

Yellow light on

“Super” function active

Press “Super” button out

Yellow light not on

Thermostat set too cold

Set thermostat warmer

Too much frost

Lid does not close

Lid in contact with

Re-arrange goods,

formed

completely

goods in freezer

check that lid closes correctly

Lot of moisture in the room

Moisture from washing machine,

Move freezer to a room with less

tumble-dryer, etc.

moisture, or air regularly

Goods packed poorly

Lot of moisture from goods

Re-pack goods, see under “How to use”

enough

This manual is related to the following products: