Yamaha MDX-E300 - Manual (Page 21)

19
EnglishEnglish
EDITING
Disc or track title erase
This operation lets you erase the title of the disc or the
title of tracks on a disc. The title of the disc can only be
erased during the stop mode, however, the title of the
track can be erased during play or stop mode.
To erase a disc title
1
Press & to set this unit to stop mode.
2
Press EDIT repeatedly to display “Title Erase?”, then
press SET/ENTER.
•
“Disc Title” and “Erase OK?” appear alternatively
in the display.
3
Press SET/ENTER again.
•
The disc title is erased and “Complete” appears
momentarily.
To erase a track title
1
Use $ or › to select the track with the title you
want to erase.
2
Press EDIT repeatedly to display “Title Erase?”, then
press SET/ENTER.
•
“Track Title” and “Erase OK?” appear
alternatively in the display.
3
Press SET/ENTER again.
•
The track title is erased and “Complete” appears
momentarily.
Notes
• Note that the DISC and TRACK indicators appear in the
display when “Title Erase” is displayed to distinguish between
the two operations.
• To avoid mistakes when erasing the disc or track names, press
DISPLAY repeatedly until the title display screen appears so
that titles can be confirmed beforehand.
Move
This function lets you change the position of any track.
When you move tracks, all tracks are automatically
renumbered.
Example: Moving track 2 to track number 4
1
Use $ or › to select the track you want to move.
Before
moving
After
moving
Before
combining
After
combining
Selected track Destination
1 2
A B D E C
3 4 5 6
1 2
A C B E D
3 4 5 6
ANALOG
DIGITAL
OPT.123
COAX.
32 44.1 48
kHz
REPEAT
MONO REC
MANUAL TOC
DISC TRACK
TOTAL
REMAIN
RANDOM
PROGRAM
A-B S F
L
R
dB – 60 30 10 6 4 2 1 0 OVER 00 – – – – – –
1 2
A B D E C
3 4 5 6
1 2
A B+C D E
3 4 5
2
Press EDIT repeatedly to display “Move ?”, then
press SET/ENTER.
3
Use $ or › to select the track’s destination (new
track number).
4
Press SET/ENTER.
• “Complete” appears momentarily in the display.
Combine
This function lets you combine two consecutive tracks
into one. After you combine the tracks, the total number
of tracks decreases by one and the tracks following the
combined tracks are renumbered.
Example: Combining tracks 2 and 3
1
Press & to stop playback.
2
Use $ or › to select the second track of the two
you want to combine.
3
Press EDIT repeatedly to display “Combine ?”, then
press SET/ENTER.
• “Check” appears momentarily, then the MD
recorder plays the 4 seconds before and after the
point where the tracks will be connected. “(track
number) + (track number) OK?” appears in the
display.
4
Press SET/ENTER again.
• The tracks are combined and “Complete” appears
momentarily.
Note
• A track recorded in MDLP mode cannot be combined with a
track recorded in the non-MDLP mode. (“Impossible” appears
in the display.)
0106MDXE300(M).17-20.E 02.5.17, 10:54 AM 19