Zanussi ZDC 67550W - Manual (Page 16)

16 electrolux programme information
Programme information
Objective Implementation
Adjusting
the level of
conductivity
Water contains, a variable quantity of limestone and mineral salts of which
quantities vary according to geographical locations thus varying its
conductivity values. Relevant variations of the conductivity of the water
compared to those prefixed by the factory could slightly influence the
residual humidity of the laundry at the end of the cycle. Your dryer allows
you to regulate the sensitivity of the drying sensor based on conductivity
values of the water by using the following procedure.
To access adjustment mode:
1. Turn the programme selector dial to switch on the appliance.
2. In selection mode,press simultaneously the buttons DRYNESS
and START.
Press the buttons down until the pilot lights above each ones begin
to flash and one of the pilot lights indicating the drying phase lights
Empty Tank, Filter and
Condenser remains it.
Adjusting the level of conductivity
:
Press the START/PAUSE button sequentially: the level of
conductivity is indicated by the phase pilot lights, which light in
various combinations as follows:
LED lit Conductivity Approximate value µS/cm
Empty Tank
Low < 300
Filter
Medium 300-600
Condenser
High >600
Normally, the appliance is factory-set to the highest level; however,
certain models may be configured differently.
Memorizing the new setting:
Simultaneously press the buttons DRYNESS and START. Press the
buttons down until the pilot lights above each ones stop flashing
and the buzzer sounds.
Off =
Cancelling/
OFF
To reset a programme and to switch off the machine turn the
selector dial to Off. Now can a new programme be selected.
125987350.qxp 2007-01-09 15:02 Page 16