Zenoah EXZ2401S - Manual (Page 38)

38
8. Operation
English
5. Set the ignition switch to the “start” position. While
pulling the throttle lever, push the set button, and
release the throttle, then the throttle lever is in to the
“start” position. (OP6)
6. While holding the unit firmly, pull out the starter rope
quickly until engine fires. (OP7)
(1) Choke lever (2) Close
(3) Open (4) Ignition switch
(5) Start (6) Stop
(7) Throttle set button
The product is equipped with a centrifugal clutch
mechanism, so the cutting attachment begins to
rotate as soon as the engine is started by pulling
the throttle. When starting the engine, place the
product onto the ground in a flat clear area and
hold it firmly in place so as to ensure that neither
the cutting part nor the throttle come into contact
with any obstacle when the engine starts. (OP8)
Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause starter
failures.
7. Move the choke lever downward to open the choke.
And restart engine. (OP5)
8. Allow the engine to warm up for a several minutes
before starting operation.
1. When restarting the engine immediately after
stopping it, leave the choke open.
2. Overchoking can make the engine hard to start due
to excess fuel. When the engine failed to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.
■ STOPPING ENGINE (OP6)
1. Release the throttle lever and run the engine for a
half minute.
2. Shift the ignition switch to the STOP position.
NOTE
IMPORTANT
WARNING
(4)
(7)
(5)
(6)
OP6
OP7
OP8