Zanussi ZHQ 575 - Manual (Page 42)

42
CLEANING THE TOP OVEN ROOF
The grill element is hinged to make cleaning the oven
roof easier.
Switch off the appliance from the
electricity supply before cleaning and
ensure the oven is cold.
1. Remove the wirework side runners. See below.
2. Undo the two screws which hold the grill element
in place.
3. Gently pull the element downwards to allow
access to the oven roof. Do not force the element
downwards.
4. Clean the top of the oven with Cif cream cleaner
and a sponge scourer. If heavily soiled, aerosol
oven cleaners may be used following the
instructions given above for cleaning the grill / top
oven compartment.
5. Gently push the grill element back into place.
6. Fit the screws to hold the element in place and
tighten firmly.
7. Replace the wirework side runners.
Ensure the screws are firmly in place after
cleaning.
CARE OF THE STAYCLEAN SURFACES
The main oven top, sides and back panel are coated
with a special Stayclean coating. They should not be
cleaned manually.
Aerosol cleaners must not be used on Stayclean
surfaces and must not come into contact with
elements or the door seal, as this may cause
damage.
During normal use the Stayclean coating will become
splashed with fats and food residues. By running the
oven without food, the Stayclean surfaces burn off
any soilage. Regular use of the oven cleaning cycle
will help to keep the panels in good condition.
THE MAIN OVEN CLEANING CYCLE
1. Remove oven shelves and bakeware from
oven.
2. Push out and turn the Selector to Fan oven
function. ( )
3. Push out and turn the main oven
temperature control to 220°C and allow the
oven to run for an hour or so.
THINGS TO NOTE
·
The main oven neon will illuminate.
·
The main oven indicator neon will turn on and off
during use.
·
The Cooling Fan for the controls will operate after
a short time. It may run on after the controls are
switched off until the appliance has cooled. See
page 8 for more details on the operation of the
cooling fan.