Xerox 4.2 - Manual (Page 19)

The table below shows the respective mappings
between DocuSP PCL Paper Sources vs. the PCL5/XL
command sequence. The mapping for PCL XL is
different from the HP so as to allow the PCL XL values
to run in sequential order.
In the table below, the Tray values numbered 8-12 are
the most popular values, as they map to HP and
CentreWare High-Capacity trays.
PCL XL Tray PCL 5
Enum Value
&l0H eDefaultSource 0
1 &l1H eManualFeed 2
2 &l2H eMultiPurposeTray 3
3 &l3H eUpperCassette 4
4 &l4H eLowerCassette 5
5 &l5H eEnvelopeTray 6
6 &l6H eThirdCassette 7
&l7H eAutoSelect 1
7 &l8H eExternalTray1 8
8 &l20H eExternalTray2 9
9 &l21H eExternalTray3 10
10 &l22H eExternalTray4 11
11 &l23H eExternalTray5 12
12 &l24H eExternalTray6 13
13 &l25H eExternalTray7 14
14 &l26H eExternalTray8 15
15 &l27H eExternalTray9 16
16 &l28H eExternalTray10 17
17 &l29H eExternalTray11 18
18 &l30H eExternalTray12 19
19 &l31H eExternalTray13 20
20 &l32H eExternalTray14 21
21 &l33H eExternalTray15 22
22 &l34H eExternalTray16 23
23 &l35H eExternalTray17 24
24 &l36H eExternalTray18 25
25 &l37H eExternalTray19 26
26 &l38H eExternalTray20 27
27 &l39H eExternalTray21 28
Mapping between the DocuSP trays and
respective PCL 5/XL commands.
DocuSP 3.8 and 4.0 to 4.1 Differences Document 15