Zanussi ZWD 1260 W - Manual (Page 8)

8
6. Start the machine
Before starting the machine check that:
● the appliance is plugged in
● the water supply taps are turned on
● the drain hose is correctly and securely positioned
● the door and the detergent dispenser drawer are
closed.
Depress the ON-OFF button: the mains-on light will
illuminate and the machine starts operating.
7. At the end of the programme
The machine stops automatically.
If you have selected the RINSE HOLD option , the
machine will stop with the water of the last
rinse left in the tub, to prevent the fabric from creasing.
To drain only, select position
or the drain
programme “S”.
To drain and spin, select programme “H” or turn the
spin speed selector dial to the desired speed position: the
machine will spin at the selected speed .
The door is controlled by a safety device which releases
2 minutes after the end of the programme.
Switch the machine off by depressing the ON-OFF
button again. The mains-on light goes out.
When the programme has finished you are advised to
unplug the appliance and turn off the water taps.
T0001S
ON-OFF
WASHING 2.5 KG OF MIXED FABRICS AT 50°C
Suppose you have 2.5 kg of Mixed fabrics to wash.
They are rather delicate fabrics and should not be
washed at a high temperature.
1. Load the laundry
Open the door by pulling the door handle outwards.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible. Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent required and pour
it into the main wash compartment
.
3. Measure out the fabric
softener
If required, pour fabric softener into the compartment
marked
(the amount used must not exceed the
“MAX” mark in the drawer).
Close the drawer gently.
C0065
C0064
P0004