Yamaha HTR-5440 - Manual (Page 35)

31
English
B
ASIC OPERA
TION
AD
V
ANCED OPERA
TION
APPENDIX
INTR
ODUCTION
PREP
ARA
TION
RECORDING A SOURCE
SILENT VIDEO AUX
PHONES S VIDEO VIDEO L AUDIO R OPTICAL
6CH INPUT INPUT MODE
INPUT
VOLUME
TUNING MODE
PRESET /TUNING FM/AM
MEMORY
EDIT
BASS BALANCE SPEAKERS
PROGRAM PRESET/TUNING EFFECT A/B/C/D/E A B
OFF ON
STANDBY /ON
D I G I T A L
– + L R
TREBLE
– +
MAN'L/AUTO FM AUTO/MAN'L MONO
SURROUND
D I G I T A L
2
1,4
Recording adjustments and other operations are performed
from the recording component. Refer to the instructions for
these components. Notes
• Do a test recording before you start an actual recording.
• When this unit is set in the standby mode, you cannot record
between other components connected to this unit.
• The DSP program and the setting of VOLUME, BASS, TREBLE
and BALANCE have no effect on the material being recorded.
• A source connected to the 6CH INPUT jacks of this unit cannot
be recorded.
• A given input source is not output on the same REC OUT
channel. (For example, the signal input from VCR 1 IN is not
output on VCR 1 OUT.)
• Check the copyright laws in your country to record from records,
CDs, radio, etc. Recording of copyrighted material may infringe
copyright laws.
•
Composite video and S video signals pass independently through
this unit’s video circuits. Therefore, when recording or dubbing
video signals, if your video source component is connected to
provide only an S video (or only a composite video) signal, you
can record only and an S video (or only a composite video) signal
by your VCR.
If you play back a video source that uses scrambled or
encoded signals to prevent it from being dubbed, the
picture itself may be disturbed due to those signals.
■ Special considerations when
recording DTS software
The DTS signal is a digital bitstream. Attempting to
digitally record the DTS bitstream will result in noise being
recorded. Therefore, if you want to use this unit to record
sources that have DTS signals recorded on them, the
following considerations and adjustments need to be made.
For DVDs and CDs encoded with DTS
Only 2-channel analog audio signals may be recorded.
Set the DVD player (or CD player) as described in the
player’s operation instructions so that the audio signals are
output from the player’s analog outputs.
2
4
Remote control
INPUT
Front panel
or
VOLUME
Front panel
VOLUME
Front panel
or
Remote control
HTR-5450 only
HTR-5450 only
(HTR-5450)
1 Set the volume at the
minimum level.
2 Select the source you want to record.
3 Begin recording by the recording component
connected to this unit.
4 Play the source and then turn up the volume to
confirm the input source.
0106HTR5450/5440_31_EN 3/28/1, 4:49 PM 31