Yamaha AX-397 EN - Manual (Page 10)

CONTROLS AND FUNCTIONS
6
1
Open the battery compartment cover.
2
Insert two supplied batteries
(AAA, R03, UM-4) according to the polarity
markings (+ and –) on the inside of the
battery compartment.
3
Close the cover back.
■ Notes on batteries
• Change all of the batteries if you notice the following
conditions; the operation range of the remote control decreases,
the indicator does not flash or its light becomes dim.
• Use AAA, R03, UM-4 batteries.
• Make sure that the polarities are correct. See the illustration
inside the battery compartment.
• Remove the batteries if the remote control is not used for an
extended period of time.
• Do not use old batteries together with new ones.
• Do not use different types of batteries (such as alkaline and
manganese batteries) together. Read the packaging carefully as
these different types of batteries may have the same shape and
color.
• We strongly recommend using alkaline batteries.
• If the batteries have leaked, dispose of them immediately. Avoid
touching the leaked material or letting it come into contact with
clothing, etc. Clean the battery compartment thoroughly before
installing new batteries.
• Do not throw away batteries with general house waste; dispose
of them correctly in accordance with your local regulations.
The remote control transmits a directional infrared beam.
Be sure to aim the remote control directly at the remote
control sensor on the front panel of this unit during
operation.
■ Handling the remote control
• The area between the remote control and this unit must
be clear of large obstacles.
• Do not spill water or other liquids on the remote
control.
• Do not drop the remote control.
• Do not leave or store the remote control in the
following types of conditions:
– places of high humidity, such as near a bath
– places of high temperature, such as near a heater or
a stove
– places of extremely low temperatures
– dusty places
• Do not expose the remote control sensor to strong
lighting, in particular, an inverter type fluorescent
lamp; otherwise, the remote control may not work
properly. If necessary, position this unit away from
direct lighting.
Installing batteries in the remote
control
1
3
2
Using the remote control
STANDBY /ON
STANDBY
INPUT PHONES SPEAKERS BASS
5
1
4
2 3
5
1
4
2 3
A
POWER
ON OFF
ON OFF
AUX MD TAPE CD/DVD TUNER PHONO PURE DIRECT CD/DVD DIRECT AMP
B
+ –
TREBLE
5
1
4
2 3
5
1
4
2 3
+ –
BALANCE
5
1
4
2 3
5
1
4
2 3
TUNER PHONO TAPE MD AUX
R L
LOUDNESS REC OUT
VOLUME
7
–30dB FLAT CD/DVD 10 9
5 6
1
4
2 3 8
30 30
0
12 12
2
8
4
∞
20 20
60 60
26 26
40 40
16 16
-dB -dB
CD/DVD PHONO TUNER
POWER
STANDBY
MD TAPE AUX
+
–
MUTE A/B/C/D/E
VOLUME
TAPE CD
u
d PRESET
DISPLAY A/B
REC DISC DIR A
p
DIR B w e f
b s a
DISPLAY
Approximately 6 m (19.7 ft)