Zanussi WIJ1075 - Manual (Page 21)

ENGLISH
89
SOMETHING NOT WORKING?
Problems which you can resolve yourself
Problem Possible cause
■ The machine does not start up: ■ Check that the door is firmly closed.
■ Check that the machine is plugged in and
that there is power at the socket.
■ Check that the main fuse has not blown.
■ Check that the programme selector dial is
positioned correctly and the ON/OFF button
depressed.
■ The machine does not fill: ■ Check that the water tap is open.
■ Check that water is coming out of the tap.
■ Check that the inlet hose is not squashed or
kinked.
■ Check that the filter in the inlet hose is not
blocked.
■ Check that the door is closed.
■
The machine fills then empties
immediately: ■ The end of the drain hose is too low. Refer to
relevant paragraph in “water drainage”
section.
■
The machine does not empty
and/or does not spin:
■
There is water on the floor: ■ Too much detergent or unsuitable detergent
(creates too much foam) has been used.
■ Check whether there are any leaks from one
of the inlet hose fittings. It is not always easy
to see this as the water runs down the hose;
check to see if it is damp.
■ Check that the drain hose is not damaged.
■ Unsatisfactory washing results: ■ Too little detergent or unsuitable detergent
has been used.
■ Stubborn stains have not been treated prior
to washing.
■ The correct temperature was not selected.
■ Excessive laundry load.
■ The machine vibrates or is noisy: ■ Check that all the transit bolts and packing
have been removed.
■ Check that the machine is not resting against
anything.
■ Check that the support feet are resting firmly
on the ground.
■ Check that the laundry is evenly distributed in
the drum.
■ Maybe there is very little laundry in the drum.
■ Check that the drain hose is not squashed or
kinked.
■ A programme which stops with water in drum
has been selected.
■ Check that the laundry is evenly distributed in
the drum.
132999660 WIJ1075.qxd 16/05/01 14.25 Pagina 89 (Nero/Process Black pellicola)