Z Microsystems 21 - Manual (Page 12)

Doc# 27-0017UM Issued 08/03 Rev 1.0
12
SETUP
VERY IMPORTANT
Hold the top of the
display in the vertical
position while rotating
the latch clockwise to
the locked position.
Push down on the latch
at the base of the
display. Then lift the
raised latch from its
receptical to the
unlatched position. Rotate the latch counter-
clockwise to unlock the
latch.
Holding the base with
one hand, lift the back of
the pivioted display up to
the vertical position.
With both hands, press
both the Z-Locks down.
SETTING UP GLIDER
Slide the Glider all the
way out to the safety
stop.
Once the display is
locked in position, lower
the latch back into the
base recepticle.
If your unit is equipped
with lock down features,
lift and slide the two
display lock knobs at the
back of the display to the
open or inward posi-
tions. This allows the
display top to be lifted
from its storage position.
The outer Z-lock bracket
fits snuggly against the
female Z-lock bracket
attached to the cabinet
frame.