Five speaker configuration, Four speaker configuration, Press the test button to run the dolby test – Yamaha RX-V890 User Manual
Page 16
16
7
STOP
VCR 1
VCR 2
V–AUX
CHAPTER/CH
—
+
DISPLAY
MASTER
VOLUME
—
+
TEST
MUTING
+
+
+
—
—
—
DSP
HALL
EFFECT
CHURCH
CENTER LEVEL
REAR LEVEL
DELAY
TIME
MOVIE THEATER
JAZZ CLUB
STADIUM
PRO LOGIC
SURROUND
SPORTS
ENHANCED
ROCK
THEATER
70mm
TV
1
2
3
4
5
6
7
8
9
10
ON/OFF
RESET
CLEAR
8
9
—
+
7
8
Select the center channel output mode according to your
speaker configuration.
(Refer to “SPEAKER CONFIGURATION” on page 7.)
CENTER
MODE
NORMAL
WIDE
PHANTOM
• If your video monitor is on, the state of the test tone output
is also shown by an image of an audio listening room on the
screen.
• The test tone from the left rear speaker and the right rear
speaker will be heard at the same time.
9
Turn up the volume using the remote
control transmitter.
You will hear a test tone (like pink
noise) from the left front speaker, then
the center speaker, then the right front
speaker, and then the rear speakers, for
about two seconds each. The display
changes as shown below.
TEST
MASTER
VOLUME
Press the TEST button to run the Dolby
test.
In step 7, when you select the center mode, note the
following.
Five speaker configuration
NORMAL:
Select this mode when you use a
center speaker that is smaller than the
front main speakers. In this mode, the
bass tone will be output from the
front speakers.
WIDE:
Select this mode when your center
speakers are approximately the same
size as the front speakers.
Four speaker configuration
PHANTOM:
Select this mode when you do not
have a center speaker. The center
channel sound will be output from
the left and right font speakers.