Zenoah BCZ3001S EU - Manual (Page 34)

34
every every every
25 50 100
system/compornent procedure before hours hours hours note
use after after after
fuel leaks, fuel spillage wipe out
✔
fuel tank, air filter, fuel filter inspect/clean
✔ ✔
replace, if necessary
see
■ADJUSTING
replace carburetor
idle adjusting screw
✔
IDLING SPEED (p.30) if necessary
clean and readjust GAP: .025in(0.6~0.7mm)
spark plug
✔
plug gap replace, if necessary
cylinder fins, intake air cooling vent clean
✔
muffler, spark arrester, cylinder exhaust port clean
✔
throttle trigger, stop switch check operation
✔
replace if
cutting parts
✔
something's wrong
cutting attachment guard make sure to attach
✔
angle transmission grease
✔
screws/nuts/bolts tighten/replace
✔ ✔
not adjusting screws
ENGINE
SHAFT
■ MAINTENANCE CHART
Maintenance, replacement, or repair of the emission control
device and systems may be performed by any non-road engine
repair establishment or individual.
9. Maintenance
English