Zenith M52W56LCD - Manual (Page 22)

MENU
EZ Scan (Channel Search)
Refer to pages 7-15 to connect external
equipment to your TV. If you have done
so, plug in your TV to a standard (non-
switched) 120V 60Hz power outlet.
If you have done so, remove the back of
the remote and install in two AA batter-
ies. Make sure batteries are properly
installed (check the +/– symbols).
With the remote control in hand, press
the POWER button to turn your TV on.
Press the MENU button on the remote
control, then use the UP/DOWN arrow
button to select the Setup menu.
Press ENTER or the RIGHT arrow button
to access the Setup menu.
Use the UP/DOWN arrow to select EZ
Scan.
Press ENTER or the Right arrow button
to start the EZ Scan channel search.
1
2
3
4
5
Automatically finds analog channels available through
ANT IN input, and stores all active over-the-air and cable
channels in memory on the channel list.
back of
remote
6
7
EZ Scan G
Ch. Edit
Ch. Label
Main Input
Sub Input
Booster
Processing EZ scan. SETUP SETUP
VIDEO VIDEO
AUDIO AUDIO
TIME TIME
LOCK LOCK
SPECIAL SPECIAL
1 2 3
4 5 6
7 8 9
0
TV
MODE LIGHT POWER
TV/VIDEO DVI
RGB
VCR CABLE DVD SAT
MUTE
SWAP PIPCH- PIPCH+ PIP
RATIO
RECORD STOP PAUSE
REW
PLAY
FF
MENU EXIT
CC FREEZE PIP INPUT
VOL CH
SURF
SAP VIDEO
COMP2 COMP1
SIDE
SKIP
ENTER FLASHBK
5/7
4/6
5/7
4/6
3
4
P A G E 2 2 206-04006
Prev.