Ordering information, Adsl2+ 1u dslam w/ modular uplinks, Technical specifications – Zhone Technologies 4929-A1-530 User Manual
Page 2: Dimensions, Weight, Power, Interfaces, Standards support, Protocol support, Bandwidth/distance

Technical Specifications
ADSL2+ 1U DSLAM w/ Modular Uplinks
Dimensions
■
Height 1U
■
Width : 430 mm (excluding the mounting wings)
■
Depth : 241mm (excluding the room for cabling)
Weight
■
2.5 lbs. (1.1 kg)
Power
■
DC: Dual -48 Volt DC terminal blocks
■
Consumption: < 1.5 Amps
■
AC: Requires separate AC power supply (sold
separately)
Interfaces
■
Access ports
■
24 ADSL2+ ports using RJ-21 connector (Annex
A)
■
24 Splitter ports using RJ-21 connector (Annex
A)
■
Uplink ports
■
1 10/100/1000BT or fiber based (SFP) GigE port
for management or uplink
■
1 RS232 Console port for RS-232 serial
management connection
■
1 Media Interface Module (MIM) slot:
- 2 x Gigabit Ethernet (MIM-2000F)
- 2 x T1 (MIM-2T1)
- 2 x E1 (MIM-2E1)
- 4 x E1 (MIM-4E1)
- 4 x T1 (MIM-4T1)
- 10/100 Ethernet (MIM-10/100)
Standards Support
■
IEEE 802.3
■
IEEE 802.1p CoS
■
IEEE 802.1Q VLAN
■
IGMP Snooping - supports IGMPv 1 and IGMPv2
Protocol Support
■
MTM Traffic Management - Configurable
Priority scheme 802.1p, DiffServ, IP address
range, Rate Limiting, Security
■
IGMP snooping
■
Enterprise MIBs “Chassis and Module
Identification, Configuration, IP Traffic
Management"
■
IETF RFC1213 “Network Management of
TCP/IP-based internets: MIB-II”
■
IETF RFC3440: “Definitions of Extension
Managed Objects for ADSL Lines”
■
ITU-G.997.1: “Physical Layer Management for
DSL Transceivers”
■
ADSL Forum Technical Report TR-024: “DMT
Line Code Specific MIB”
■
Flash Upgradeable
Bandwidth/Distance
■
Bandwidth: Maximum within ITU ADSL2+
standard
■
Distance: up to 18,000 feet/7,500m (lower
speeds will be achieved at greater distances)
Regulatory Compliance
■
NEBS: GR-63-CORE, GR-1089-CORE
■
EMC: FCC Part 15; ICES-003; EN 300 386-2; CE
Marking
■
Safety: UL1950, CSA C22.2 No. 950, EN60950,
IEC950, CE Marking
Operating Requirements
■
Complies to ETSI 300-019-1-3 Environmental
Requirements
■
Climatic conditions Classes 3.1 to 3.3
■
Temperature: -40ºF to 149ºF (-40ºC to 65ºC)
■
Non-operating temperature: -40ºF to 158ºF
(-40ºC to 70¼C)
■
Humidity: 5% to 95%, non-condensing
■
Altitude: -200ft to 16,600ft (-60m to 5,000m)
Ordering Information
4929-A1-520
ADSL2+ Annex A unit with no integrated splitter
4929-A1-530
ADSL2+ Annex A unit with integrated Annex A 900 ohm splitter
EPC-AC-2.5A-US
Optional AC Power Supply, 2.5A, US plug
EPC-AC-2.5A-UK
Optional AC Power Supply, 2.5A, UK plug
EPC-AC-2.5A-EU
Optional AC Power Supply, 2.5A, EU plug
17 December 2010 11:30:01