ZALMAN CNPS7700 - Manual (Page 7)

6
.COM
Install the L-Type Grip to both sides of the Clip and fasten Bolts through
the holes of the Grips onto the Clip Support.
Connect Fan Mate 2 between the
Fan Cable and the motherboard
as shown in the diagram below.
Fan Mate 2 can be installed to the
side of the case using Double-Sided
Tape.
M/B
Fan Connector (Cooler)
Double-Sided Tape
6. Fan Mate 2 Installation and Usage
1) Fan Mate 2 Installation
2) Fan Mate 2 Operation
Adjust the Fan Speed Control
Knob for RPM control.
Fan Speed Control Knob
In the case that you get a BIOS error beep:
Rotate the Fan Speed Control Knob clockwise to the maximum setting.
Disable CPU Fan Detected in BIOS setting or set the system monitoring
program’s CPU Fan RPM to the lowest setting.
※ Certain motherboards will not boot if the CPU fan’s RPM is not detected. In this
case inquire to the motherboard’s manufacturer for additional details.
BIOS Booting Error