Zenoah EHT752S - Manual (Page 10)

GB-10
eHT752S / eHT602D
6. While holding the unit firmly, pull out the starter rope
quickly until engine fires.
7. After the engine has started, allow the engine to warm
up. Pull the throttle lever.
STOPPING ENGINE
1. Release the throttle lever and run the engine for half
a minute.
2. Shift the ignition switch to the STOP position.
NOTE
If the engine doesn’t stop after stopping the switch, close
the choke so that engine will stop after a little.
7. Operation
STARTING ENGINE
WARNING
The cutting head will start moving upon the engine
starts.
1. Release the throttle lever and make sure it is fully back.
2. Set the ignition switch to the “I” position.
(a) Throttle lever (b) Ignition switch
3. Push the primer pump several times until overflown
fuel flows out in the clear tube.
(a) Primer pump (b) Clear tube
4. Move the choke lever to the closed position.
(a) Choke lever (b) Open (c) Close
5. Place the unit on a flat, firm place. Keep the cutting
head clear of everything around it.