Zanussi FJD 1466 W - Manual (Page 18)

18
If the filter is blocked and the machine is unable to drain
you will need to drain the water manually from the
machine at this stage. To do this, unhook the drain hose
from the standpipe or sink and hold the end of the hose
over a bowl on the floor. The water should drain by
gravity into the bowl. When the bowl is full, hook the
hose back up and empty the bowl. Repeat the procedure
until water stops flowing out.
Unscrew and remove the filter.
Clean carefully under a fast running tap.
Put the cap back on the emergency emptying hose,
place the latter back in its seat. Close the filter door.
Warning
When the appliance is in use and depending on the
programme selected there can be hot water in the filter.
Never remove the filter during a wash cycle, always
wait until the appliance has finished the cycle, and is
empty. When replacing the filter, ensure it is securely
retightened so as to stop leaks and young children being
able to remove it.
The water inlet filter
If your water is very hard or contains traces of lime
deposit, the water inlet filter may become clogged.
It is therefore a good idea to clean it from time to time.
Turn off the water tap. Unscrew the water inlet hose.
P0040
P0859 P0860
Clean the filter using a hard bristle brush.
Tighten up the inlet hose.
The dangers of freezing
If the machine is exposed to temperatures below 0°C,
certain precautions should be taken.
● Turn off the water tap.
● Unscrew the inlet hose.
● Unhook the drain hose from the rear support and
position the end of this hose and that of the inlet
hoses in a bowl. Run the draining programme.
To do this:
● Switch the machine on
● Select a washing programme
● Press the SKIP/RESET button three times
● Press START/PAUSE button
● Disconnect the appliance.
● Screw the inlet hose and reposition the drain hose.
● When you intend to start the machine up again,
make sure that the room temperature is above 0°C.
P1090
132994630 .qxd 6/6/02 3:00 PM Pagina 18 (Nero/Process Black pellicola)