Yamaha CDV-W901 - Manual (Page 8)

8
CONNECTIONS
Connection method (Be sure to plug the cords securely deep into the connectors.)
1 Connect the VIDEO OUT jack of the player to the video input jack of a TV (or a TV monitor).
If the TV set has an S VIDEO input jack, connect it using an S VIDEO cable which is available in audio/video stores.
For use of the S VIDEO cable, also read the operating instructions of the TV,
2 Connect the AUDIO OUT jacks of the player to the audio input jacks of the TV.
3 Finally plug the power cord into a household power outlet (which should permanently be supplied with power).
Also read the instruction manual of the TV.
Connection with a TV set equipped with Video/Audio inputs
AC-3 RF OUT terminal:
This terminal is intended for use with Dolby* AC-3 (*1) compo-
nents
With this terminal, you will be able to connect an AC-3 RF
input to amplifiers and surround processors, and playback laser
discs formatted with Dolby AC-3 (*2).
( ∗1) Indicated with (For hardware)
( ∗2) Indicated with (For software)
You cannot playback currently available laser discs, laser disc
players, AV amplifiers, etc., with this terminal.
Do not connect this terminals to the audio input terminal of a
normal stereo or AV amplifiers.
V
L
R
1 2
1
2
OFF ON
V
L R
VIDEO
OUT
S-VIDEO
OUT
ATTENUATOR
AUDIO OUT
OPTICAL
DIGITAL OUT
2/R 1/L
2
1
S VIDEO
VIDEO
OUT
AUDIO
R
L
AC-3 RF OUT
OFF ON
ATTENUATOR
S VIDEO plug
Check the
positions of
the holes of
the S VIDEO
jack before
insertion.
S VIDEO input jack
Commercially-available
S VIDEO cable
VIDEO input jack
Accessory video cord
AUDIO input jacks (A/V TV)
Plug into a
household power
outlet after
completing all
connections.
7 ATTENUATOR switch
Usually, set this switch to the OFF position.
Set to ON when the audio is distorted during karaoke singing.
Usually OFF
* "Dolby", "AC-3" and the double-D symbol are trademarks of Dolby
Laboratories Licensing corporation.
Accessory audio cord
•
•
•
•
•