Zanussi ZFC 321 WB - Manual (Page 9)

Installation
Positioning
Warning! If you are discarding an old appliance that
has a lock or catch on the lid, you must ensure that
it is made unusable to prevent young children being
trapped inside.
Important! The appliance shall have the plug accessible
after installation.
This appliance can be installed in a garage or cellar, but
for optimum performance install this appliance at a loca-
tion where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance:
Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical Connection
Caution! Any electrical work required to install this
appliance should be carried out by a qualified
electrician or competent person.
Warning! This appliance must be earthed.
The manufacturer declines any liability should these
safety measures not be observed.
1 2
3
4
5
Important! The wires in the mains lead are coloured in
accordance with the following code:
1 Green and Yellow: Earth
3 Brown: Live
5 Blue: Neutral
As the colours of the wires in the mains lead of this ap-
pliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
1. Connect the wire coloured green and yellow to the
terminal marked either with the letter “E“ or by the
earth symbol or coloured green and yellow.
2. Connect the wire coloured blue to the terminal either
marked with the letter “N“ or coloured black.
3. Connect the wire coloured brown to the terminal ei-
ther marked with the “L“ or coloured red.
4. Check that no cut, or stray strands of wire is present
and the cord clamp
4
is secure over the outer
sheath.
5. Make sure the electricity supply voltage is the same
as that indicated on the appliance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug fitted
2 .
In the event of having to change the fuse in the plug sup-
plied, a 13 amp ASTA approved (BS 1362) fuse must be
used.
9