beautypg.com

Setup and adjustments, Rops assembly (roll over protection system), Tires – Yazoo/Kees ZHDD61271 User Manual

Page 15

background image

15

ROPS Assembly
(Roll Over Protection System)

ROPS Assembly Components

1 - Top Loop
1 - Left Side Post
1 - Right Side Post
1 - Hardware Bag
2 - 1/2” Latch Pins w/lanyard
2 - 1/2C x 3 1/4” Cap screws
2 - 1/2C Centerlock nuts
4 - 5/8C X 3” Cap screws
4 - 5/8C Centerlock nuts
8 - 5/8 Washer, flat
2 - Knobs
(all hardware Grade 5).

1. Remove roll bar and parts bag from the box.

2. Install roll bar side posts.

a. Locate the LEFT and RIGHT side posts.
b. Using 5/8C x 3 cap screws, two per

post, align the holes in the side post with
the frame holes.

d. Install the 5/8C centerlock nuts finger tight

to the side post bolts.

3. Install roll bar top loop.

a. Align the holes of the top loop with the left

and right side posts.

b. Slide the latch pins thru the front hole on

the left and right side to connect the top
loop to the side posts and secure with the
hairpin.

c. Using 1/2C x 3 1/4 cap scrws thru the

rear hole on the left and right side.

d. Install the 1/2C centerlock nuts finger

tight.

4. Torque all 1/2” hardware to 80 ft./lbs. (110 N•m)

and all 5/8” hardware to 97 ft/lbs. (131.5 N•m).

5. Install and tighten knobs against the side post.

LATCH PIN

1/2C X 3 1/4
CAPSCREW

KNOB

1/2C CENTERLOCK
NUT

LEFT SIDE
POST

RIGHT SIDE
POST

TOP LOOP

5/8C CENTERLOCK
NUTS

5/8C X 3
CAPSCREWS

Mount rear drive wheels using the lug nuts installed
on the hubs.

Check the tire pressure in all four tires. All tires
should be 16 psi.

Tires

SETUP AND ADJUSTMENTS

This manual is related to the following products: