Zephyr ZMI-M90G - Manual (Page 9)

Blower On/Off
By pressing , the blower is switched On and Off. When switched on, the blower starts up on
speed level 3.
Speed Selection
The 6 speed levels are selected by pressing to decrease and to increase speed level. The
display indicates level selected.
Delay Off
This is used for programmed shut down of blower and lights 15 minutes after the function is
activated. Press once, a dot flashes in the lower right hand side of display indicating
the function is on. The hood will completely shut down in 15 minutes.
Lights On/Off/ Dim
Switch lights On and Off by pressing key once. To dim lights, press and hold- for 2
seconds.
Advance Display Functions
Filters Clean Reminder (Metal):
After every 30 hours of use, the display will start flashing an reminding you to clean the
metal filters from residue and possible clogs.
The standard Metal Filters fitted are required to be cleaned frequently and as recommended in
order to maintain blower efficiency. If improperly maintained, residue from cooking will sift
through filters and cause damage to hood blowers and other sensitive components; and possibly
clog duct work and creates fire hazard.
Filters Change Reminder (Carbon, if fitted):
When your hood is installed as a 'Purifying' (Ductless Recirculating) unit, it is fitted with a set of
Carbon Filters to purify exhaust and fumes from cooking, and re-circulates the air within the home.
These Carbon Filters are required to be replaced after every 120 hours of use. The Filter Change
Reminder function in the microprocessor needs to be switched on. The microprocessor in the
controls when set, will elapsed and count usage time and indicate when carbon filter replacement is
needed every 120 hrs.
FEATURES & CONTROLS
6
TOUCH CONTROLS & FEATURES
Blower On/Off
Adjust 6 Speed Levels
15 Min Delay Off
Lights On/Off/ Hold to Dim
Display
(Speed level, Delay Off Indicator, Filter Clean/ Change)
1
1
2
2
3
3
4
4
5
5