Yamaha YAS-71CU - Manual (Page 34)

USING OPTIONAL EQUIPMENT
30
En
4
Press and hold
BLUETOOTH ON for more than 3 seconds to start pairing.
“Searching...” appears when the pairing starts. While the Yamaha Bluetooth audio receiver is in pairing mode, the
DOCK indicator flashes in the front panel display.
y
To cancel the pairing, press BLUETOOTH OFF.
5
Check that the Bluetooth component detects the Yamaha Bluetooth audio receiver.
If the Bluetooth component detects the Yamaha Bluetooth audio receiver, the audio receiver name (“YBA-10
YAMAHA” for example) appears in the device list of the Bluetooth component.
6
Select the Yamaha Bluetooth audio receiver in the device list of the Bluetooth component, and
then enter the pass key “0000” on the Bluetooth component.
When the pairing procedure is successful, “Completed” appears in the front panel display.
y
• If the pairing is not completed within 8 minutes, “Not found” appears and the DOCK indicator is turned off in the front panel
display.
• If the pairing is canceled during the pairing, “Canceled” appears in the front panel display.
The Yamaha Bluetooth audio receiver can be paired with up to eight Bluetooth components. When pairing is conducted successfully
with a ninth component and the pairing data is registered, the pairing data for the least recently used another component is deleted.
■ Establishing a connection
After the pairing is completed, perform the connecting operation on the system or on the Bluetooth component to enable
communication between them. The connecting operation on the system is only available for the most recently connected
Bluetooth component.
1
Press
DOCK to set the input to DOCK.
2
Press
BLUETOOTH ON to start a connection. “Searching...” appears in the front panel display.
When the system finds the last connected Bluetooth component, “BT connected” appears in the front panel display
for 3 seconds.
y
• If the system cannot find the last connected Bluetooth component, “Not found” appears in the front panel display.
• If you want to establish a connection with a Bluetooth component other than the one most recently connected to, connect from
that Bluetooth component. Refer to the instruction manual of your Bluetooth component for details.
■ Disconnecting
Press
DOCK, and then BLUETOOTH OFF to disconnect the system from the Bluetooth
component.
“Disconnected” appears in the front panel display.
■ Playing back the Bluetooth component
You can play back your Bluetooth component using the supplied remote control.
You can also play back your Bluetooth component by operating it directly.
y
Operation using the remote control is available only when the connection is established between the Bluetooth component you want to
play back and the system.
Note