Yamaha RX-385 - Manual (Page 24)

24
SPECIFICATIONS
AUDIO SECTION
Minimum RMS Output Power per Channel
8 ohms, 20 Hz to 20 kHz, 0.04% THD
< RX-485 RDS > ............................65W+65W
<
RX-385/385 RDS
>
[U.S.A. and Canada models].......45W+45W
[Australia, U.K., Europe and
General models]..........................40W+40W
6 ohms, 20 Hz to 20 kHz, 0.06% THD
< RX-485 RDS > ............................70W+70W
< RX-385/385 RDS >
[U.S.A. and Canada models].......48W+48W
Dynamic Power per Channel
(by IHF Dynamic Headroom measuring
method)
<
RX-485 RDS
>
8/6/4/2 ohms ....................95/115/135/150W
< RX-385/385 RDS >
[U.S.A., Canada and General models]
8/6/4/2 ohms ..........................69/78/90/98W
[Australia, Europe and U.K. models]
8/6/4/2 ohms ..........................68/75/85/95W
DIN Standard Output Power per Channel
4 ohms, 1 kHz, 0.7% THD
[Europe model only]
<
RX-485 RDS
>
......................................85W
< RX-385/385 RDS > ...............................55W
IEC Power
< RX-485 RDS >
8 ohms, 1 kHz, 0.04% THD
[Europe model only]..............................75W
< RX-385/385 RDS >
8 ohms, 1 kHz, 0.04% THD
[Europe model only]..............................50W
Damping Factor
8 ohms, 20 Hz to 20 kHz ............................80
Input Sensitivity/Impedance
PHONO MM ......................2.5 mV/47 k-ohms
CD/TAPE/AUX ..................150 mV/47 k-ohms
Maximum Input Signal (1 kHz, 0.01% THD)
PHONO MM .........................................80 mV
Headphone Jack Rated Output/Impedance
8 ohms, 20 Hz to 20 kHz, 0.04% THD
Output Level
< RX-485 RDS > ....................................0.46V
< RX-385/385 RDS > .............................0.45V
Impedance
< RX-485 RDS > .............................390 ohms
<
RX-385/385 RDS
>
......................330 ohms
Frequency Response (20 Hz to 20 kHz)
CD/TAPE/AUX..................................0±0.5 dB
RIAA Equalization Deviation
PHONO MM .....................................0±0.5 dB
Total Harmonic Distortion (20 Hz to 20 kHz)
PHONO MM to REC OUT (1V) ............0.02%
CD/TAPE/AUX to SP OUT
< RX-485 RDS >
(32.5W/8 ohms) ....................................0.02%
< RX-385/385 RDS >
(22.5W/8 ohms) ....................................0.02%
Signal-to-Noise Ratio (IHF-A Network)
PHONO MM (5 mV Input Shorted)........82 dB
CD/TAPE/AUX (Input Shorted) ...........105 dB
Residual Noise (IHF-A Network)............100
µ
V
Channel Separation (Vol. –30 dB)
PHONO MM (Input Shorted 1 kHz) .......60 dB
CD/TAPE/AUX
(Input 5.1 k-ohms Terminated 1 kHz)....60 dB
Tone Control Characteristics
BASS: Boost/cut .................±10 dB (50 Hz)
(Turnover frequency)
...........................................(350 Hz)
TREBLE: Boost/cut............±10 dB (20 kHz)
(Turnover frequency)
..........................................(3.5 kHz)
Continuous Loudness Control
...............................................– 30 dB (1 kHz)
(Level related equalization)
FM SECTION
Tuning Range
[U.S.A., Canada and General models]
........................................87.5 to 107.9 MHz
[Australia, Europe, U.K. and General
models] ...........................87.5 to 108.0 MHz
50 dB Quieting Sensitivity (IHF, 75 ohms)
< RX-485 RDS/385 >
[Except Europe model]
Mono ...............................1.55
µ
V (15.1 dBf)
Stereo ................................21 µ V (37.7 dBf)
<
RX-385 RDS
>
Mono ...............................1.55 µ V (15.1 dBf)
Stereo ................................21
µ
V (37.7 dBf)
Usable Sensitivity (75 ohms)
(30 dB S/N Quieting, 1 kHz, 100% mod.)
< RX-485 RDS/385 >
[Except Europe model]
............................................0.8
µ
V (9.3 dBf)
DIN, Mono (S/N 26 dB) [Europe model]
.............................................................0.9
µ
V
DIN, Stereo (S/N 46 dB) [Europe model]
..............................................................24
µ
V
< RX-385 RDS >
[Except Europe and U.K. models]
............................................0.8
µ
V (9.3 dBf)
DIN, Mono (S/N 26 dB)
[Europe and U.K. models] .................0.9
µ
V
DIN, Stereo (S/N 46 dB)
[Europe and U.K. models] ..................24
µ
V
Image Response Ratio
< RX-485 RDS/385 >
[Except Europe and U.K. models].......45 dB
[Europe model] ...................................80 dB
<
RX-385 RDS
>
[Except Europeand U.K. models]........45 dB
[Europe and U.K. models]...................80 dB
IF Response Ratio ...................................80 dB
Spurious Response Ratio ........................70 dB
AM Suppression Ratio .............................55 dB
Capture Ratio..........................................1.5 dB
Alternate Channel Selectivity
< RX-485 RDS/385 >
[Except Europe model] .......................85 dB
< RX-385 RDS >
[Except Europe and U.K. models].......85 dB
Selectivity (two signals, 40 kHz Dev.)
< RX-485 RDS/385 >
[Europe model] ...................................70 dB
< RX-385 RDS >
[Europe and U.K. models]...................70 dB
Signal-to-Noise Ratio
< RX-485 RDS/385 >
(IHF) Mono/Stereo
[Except Europe model] .............80 dB/75 dB
(DIN-Weighted, 40 kHz Dev.) Mono/Stereo
[Europe model] .........................74 dB/69 dB
<
RX-385 RDS
>
(IHF) Mono/Stereo
[Except Europe and U.K. models]
.................................................80 dB/75 dB
(DIN-Weighted, 40 kHz Dev.) Mono/Stereo
[Europe and U.K. models] ........74 dB/69 dB
Harmonic Distortion
<
RX-485 RDS/385
>
Mono/Stereo (1 kHz)
[Except Europe model] ................0.1/0.2%
Mono/Stereo (40 kHz Dev.)
[Europe model] ............................0.1/0.2%
<
RX-385 RDS
>
Mono/Stereo (1 kHz)
[Except Europe and U.K. models]
....................................................0.1/0.2%
Mono/Stereo (40 kHz Dev.)
[Europe and U.K. models] ...........0.1/0.2%
Stereo Separation
<
RX-485 RDS/385
>
(1 kHz)................50 dB
< RX-385 RDS >
[Except Europe and U.K. models]
(1 kHz)...................................................50 dB
[Europe and U.K. models]
(40 kHz Dev.) ........................................50 dB
Frequency Response
20 Hz to 15 kHz...............................0 ±1.5 dB
AM SECTION
Tuning Range
[U.S.A., Canada and General models]
..........................................530 to 1,710 kHz
[Australia, U.K., Europe and General
models] .............................531 to 1,611 kHz
Usable Sensitivity ..............................100 µ V/m
Selectivity.................................................32 dB
Signal-to-Noise Ratio ...............................50 dB
Image Response Ratio ............................40 dB
Spurious Response Ratio ........................50 dB
Harmonic Distortion...................................0.3%
AUDIO SECTION
Output Level/Impedance
< RX-485 RDS/385 >
FM (100% mod., 1 kHz)
[Except Europe model]
......................................500 mV/2.2 k-ohms
[Europe model (40 kHz Dev.)]
......................................400 mV/2.2 k-ohms
AM (30% mod., 400 Hz)
.........................................150 mV/2.2 k-ohms
<
RX-385 RDS
>
FM (100% mod., 1 kHz)
[Except Europe and U.K. models]
......................................500 mV/2.2 k-ohms
[Europe and U.K. models (40 kHz Dev.)]
......................................400 mV/2.2 k-ohms
AM (30% mod., 400 Hz)
.........................................150 mV/2.2 k-ohms
GENERAL
Power Supply
[U.S.A. and Canada models]
...........................................AC 120V, 60 Hz
[Australia and U.K. models]
...........................................AC 240V, 50 Hz
[Europe model] ...................AC 230V, 50 Hz
[General model]
.................AC 110/120/220/240V, 50/60 Hz
Power Consumption
<
RX-485 RDS
>
[U.S.A. model].....................................155W
[Canada model].....................250 VA, 205W
[Europe, Australia and General models]
............................................................135W
<
RX-385/385 RDS
>
[Canada model] ..................................170W
[U.S.A., Australia, Europe, U.K. and
General models] .................................120W
AC Outlets
2 SWITCHED OUTLETS
[U.S.A., Canada, Europe and
General models].................100W max. total
1 SWITCHED OUTLET
[Australia and U.K. models]
...........................................100W max. total
Dimensions (W x H x D)
..........................................435 x 126 x 298 mm
(17-1/8” x 4-15/16” x 11-3/4”)
Weight
< RX-485 RDS > .............7.0 kg (15 lbs. 6 oz.)
<
RX-385/385 RDS
>
......6.1 kg (13 lbs. 7 oz.)
Accessories............................AM loop antenna
Indoor FM antenna
Remote control transmitter
Batteries
Specifications are subject to change without
notice.