Yamaha HTR-5630RDS - Manual (Page 44)

42
SOUND 2 SP DISTANCE
(speaker distance)
Use this feature to adjust the delay applied to center
channel sounds. This feature works when there is sound
output from the center speakers with a source such as
Dolby Digital or DTS. Ideally, the center speaker should
be the same distance from the main listening position as
the left and right main speakers. However, in most home
situations, the center speaker is placed in line with the
main speakers. By delaying the sound from the center
speaker, you can adjust the apparent distance from the
center speaker to the main listening position to make it
seem the same as the distance between the listening
position and main left and right speakers.
1 Press u / d to select “UNIT”.
2 Press –/+ to select the unit “meters” or “feet”
to be used in setting.
3 Press u / d to select the speaker for which
you want to adjust the delay.
4 Press –/+ to set the delay.
Press + for higher values and – for lower values.
■ Setting by “meters”
Control range: 0.3 to 24.00 m (for main L/R,
center, rear L/R)
Initial settings: 3.00 m (for main L/R, center,
rear L/R)
■ Setting by “feet”
Control range: 1 to 80 ft (for main L/R, center,
rear L/R)
Initial settings: 10.0 ft (for main L/R, center,
rear L/R)
Note
• No delay will be set if you set the same distance for the main
L/R, center and rear L/R.
SOUND 3 LFE LEVEL
Use this feature to adjust the output level of the LFE
(low-frequency effect) channel when playing back a
Dolby Digital or DTS signal. The LFE signal carries low-
frequency special effect sound which is only added to
certain scenes.
Control range:
SPEAKER ............ –20 to 0 dB
HEADPHONE ..... –20 to 0 dB
Initial setting: 0 dB
1 Press u / d to select the item to be
adjusted.
2 Press – to adjust the LFE level.
Note
• Adjust the LFE level according to the capacity of your
subwoofer or headphones.
SOUND 4 D. RANGE
(dynamic range)
Use this feature to adjust the dynamic range. This setting
is effective only when the unit is decoding Dolby Digital
signals.
Choices: MAX, STD (standard), MIN (minimum)
MAX
Select MAX for feature films.
STD
Select STD for general use.
MIN
Select MIN for listening to sources at low volume levels.
SET MENU
L C
C
R
RL RR
Center speaker image
09V340G_40-45_EN(03.3.4)a.p65 03.4.14, 11:51 AM 42