Various ways of connecting the subwoofer – Yamaha NS-P610 User Manual

Page 12

E-

Notes

● Some amplifiers have line output terminals labeled PRE

OUT. When you connect the subwoofer to the PRE OUT
terminals of the amplifier, make sure that the amplifier
has at least two sets of PRE OUT terminals. If the
amplifier has only one set of PRE OUT terminals, do not
connect the subwoofer to the PRE OUT terminals.
Instead, connect the subwoofer to the speaker output
terminals of the amplifier. (Refer to pages 6 and 7.)

● When connecting to a monaural line output terminal of

the amplifier, connect the L INPUT2 terminal.

● When connecting to line output terminals of the amplifier,

other speakers should not be connected to the OUTPUT
terminals on the rear panel of the subwoofer. If
connected, they will not produce sound.

Subwoofer (General model)

Amplifier

Pin plug cord
(included)

To AC outlet

Various ways of connecting the subwoofer

● To connect with a YAMAHA DSP amplifier (or AV

receiver), connect the SUBWOOFER (or LOW PASS etc.)
terminal on the rear of the DSP amplifier (or AV receiver)
to the L INPUT2 terminal of the subwoofer.

Ⅵ

Connecting the subwoofer to line output (pin jack) terminals of
the amplifier (The basic way)

Connect the main speakers to the speaker output terminals of the amplifier.

● To connect the subwoofer to the SPLIT SUBWOOFER

terminals on the rear of the DSP amplifier, connect them
to both the left L and right R INPUT2 terminals of the
subwoofer.

Pin plug cords
(not included)

OUTPUT

INPUT2

TO SPEAKERS

INPUT1

FROM AMPLIFIER

LOW

HIGH

OFF

AUTO

STANDBY

240V

VOLTAGE

SELECTOR

POWER

OFF