Using the pure direct switch, Setting the subsonic filter switch, Setting the phono switch – Yamaha AX-1070/870 User Manual

Page 11: Setting the mode switch, For ax-1070 only, English

English

When you listen with headphones

Connect the headphones to the PHONES jack. When listening
with headphones privately, set both the SPEAKERS A and B
switches to the OFF position.

Using the PURE DIRECT switch

You can enjoy the purest possible sound from your audio
sources by setting this switch so that the indicator illuminates.
By doing so, the audio signal bypasses the BASS, TREBLE,
BALANCE and LOUDNESS controls, the SUBSONIC FILTER
switch and the PRE OUT/MAIN IN terminals, eliminating any
alterations to the audio signal.

Setting the SUBSONIC FILTER switch

If you set this switch to “ON” position, undesirable ultra-low-
frequency signals caused by turntable rumble or warped
records can be cut out without losing sound quality.

Setting the PHONO switch

Select either MM or MC position depending on your PHONO
cartridge, Moving Magnet or Moving Coil type. However, if you
use a high output MC cartridge, select MM position.

Setting the MODE switch

For AX-1070 only

This switch can be used for switching between stereo and
monaural operation. Normally this switch should be set to the
STEREO position.

PURE

DIRECT

PHONO

SUBSONIC

FILTER

OFF

MONO

STEREO

MODE

PHONES