Zenoah RedMax EBZ8001 - Manual (Page 13)

GB-13
G
B
EBZ8001
AIR INLET NET
IMPORTANT
• Blowing air is taken in from the air inlet net. When air
flow has dropped down during operation, stop the
engine and inspect the air inlet net for blocking by
obstacles.
• Note that failure to remove any such obstacles may
result in the engine becoming overheated and dam-
aged.
(1)
(1)Net
WARNING
Never use the blower without the net of the blower.
Before each use, check that the net is attached in
place and is free from any damage.
IGNITION COIL AIR GAP INSPECTION
• If the gap is out of standard or when installing the coil
or rotor, adjust the air gap between the ignition coil
and the iron core of the rotor.
Air Gap:
0.40mm (0.35 ~ 0.45mm)
0.016" (0.014 ~ 0.017")
(1) Rotor
(2) Ignition coil
SHOULDER STRAP
• If the shoulder strap is damaged it may break during
use, thus causing the product to fall and resulting in
personal injury. Follow the instructions below to re-
place the shoulder strap with new one.
• Take off the clip from the strap.
• Pass the end of the strap through the hanger.
• Return the clip to the strap.
(1)
IMPORTANT
• Make sure that the thick round bar of the clip is in
the strap. If it is attached in the wrong way, it leads
to serious personal injury.
• Do not apply liquid type screw lock glue on screws
or bolts used to fix plastics components. Adher-
ence of this type of glue may cause cracks on plas-
tics and end up with the breakage.
9. Maintenance
10. Storage
BEFORE STORING THE BLOWER:
1. Drain a fuel tank and push the primer bulb until it be-
comes empty of fuel.
2. Remove the spark plug and drop a spoonful of 2-cycle
oil into the cylider. Crank the engine several times and
install the spark plug.
3. Store unit in a dry, dust free place, out of the reach of
children.
(1) Clip
11. Disposal
When disposing your machine, fuel or oil for the machine,
be sure to allow your local regulations.