Yamaha NS-P220 - Manual (Page 12)

8
Main/center/rear speakers
One side of the provided speaker cord has a white broken
line and the other side has no line.
Connect the (+) terminals on both the speaker and the
amplifier using the side with a white broken line. Connect
the (–) terminals on both components using the side with no
line.
Red: positive (+)
Black: negative (–)
Subwoofer (INPUT1/OUTPUT terminals)
Connect the (+) terminals on both the subwoofer and the
amplifier using one side of the cord. Connect the (–)
terminals on both components using the other side of the
cord.
Red: positive (+)
Black: negative (–)
Ⅵ
How to connect speaker cords to the input and output terminals
of the speakers
For connections, keep the speaker cords as short as possible. Do not bundle or roll up the excess part of the cords. If the
connections are faulty, no sound will be heard from the speakers.
10 mm
How to Connect:
1
Press and hold the terminal’s tab, as shown in the
figure.
2
Insert the bare wire end properly into the terminal hole.
[Remove approx. 10 mm (3/8”) insulation from the
speaker cord.]
3
Release your finger from the tab to allow it to lock
securely on the cord’s wire end.
4
Test the firmness of the connection by pulling lightly on
the cord at the terminal.
Note
Do not let the bare speaker wires touch each other as
this could damage the speaker or the amplifier, or both
of them.
White broken line