Zanussi ZUT 6245S - Manual (Page 7)

7
Using the Appliance
Before Use
Remove all packaging and securing tapes. Wash
inside the appliance with lukewarm water and
bicarbonate of soda (5 ml to 0,5 litre of water). Do not
use soap or detergent as the smell may linger. Dry
thoroughly.
Do not use detergents, abrasive powders,
highly perfumed cleaning products, wax
polishes or products containing alcohol.
)
To Start the Appliance
1. Allow the appliance to stand for 2 hrs after
installation.
2. Plug in the appliance and switch on at the mains
supply.
Thermostat Control
The temperature within the freezer is controlled by the
thermostat situated on the control panel.
0 = Off
Turning the thermostat clockwise makes the
temperature progressively colder.
Freezing Fresh Food
It is important that fresh food placed in the freezer is
frozen quickly and that the food already in the freezer
is heated as little as possible.
)
If more than 3-4 kg of food is to be frozen:
1. Switch on the fast freeze freezer switch (pops up
and lights by pressing) 4 hours before freezing food
of small quantities and about 24 hours before
freezing products of larger quantities. This time the
compressor operates continuously to reach the
temperature necessary for freezing.
2. Place in the foods to be frozen and let the appliance
operate for about 24 hours as written above.
3. Then push the fast freezer switch again (the yellow
light will go out and the switch turns to its original
position).