weber 700 Series - Manual (Page 20)

20
Step 20
Complete accessory installation
You will need: work table, accessory rack, warming rack,
three tubing plugs and thermometer.
Set the accessory rack across the bottom braces in front
of the frame connector. Figure 26 (a).
Open the lid and set the warming rack into the slots at the
rear of the cooking box. Figure 26 (b).
Set the work table onto the left side rails. Figure 26 (c).
Note: Work table should rest between the frame rails and on
the work table spacer installed in “Add cooking box” step.
Insert the thermometer into its holder. Figure 26 (d).
Insert the tubing plugs into the ends of the frame. To fully
seat the plugs, you may have to tap them lightly with a
hammer. Figure 26 (e).
Figure 26
(a)
(d)
(b)
(e)
(c)
Work table spacer
Work table