Wachsmuth & Krogmann FL-258 - Manual (Page 7)

6
OPERATION
Glue gun can be used for wood working projects, hobby and crafts.
WARNING: Glue Gun can get very hot use with caution!
FOLD DOWN STAND
• Attach wire stand to nose of the glue gun.
• During operation the stand must be folded down to allow safe positioning
between gluing.
• When the gun is not in use and being stored, the stand (1) can be folded out of
the way.
LOADING GLUE STICK
• Insert the glue stick into the gun through the feeder tube (4).
• Press trigger several times until glue stick is firmly set into feeder tube.
• Allow glue gun to warm up approximately 5 minutes.
• To further load the stick into the gun, squeeze the trigger several times. When
the glue stick is near completion, a second stick can be inserted into the feeder
tube to push out the remains of the previous stick.
TRIGGER
• The glue sticks must be allowed to heat fully to flow properly.
• To start flow of the hot glue, squeeze trigger (6). The trigger may require
continuous pressure initially to begin flow.
• Press glued surface together for 15 seconds. Use of clamps or other holding
devices are not necessary.
IMPORTANT
: When finished, unplug the glue gun from outlet and allow gun to cool.
No clean up is required. Do not attempt to remove unused glue sticks from the gun.
Unused glue can be kept in gun and used later. Do not store glue gun until fully cooled.
MAINTENANCE
CLEANING
• Clean glue gun, when unplugged but slightly warm, by using a citrus-based
solvent cleaner sold at most grocery stores.
• To get glue off fabric, chill the fabric and crack glue off.