Wright Manufacturing Roll Over Protective Structure 98210001 - Manual (Page 2)

INSTALLATION INSTRUCTIONS FOR
ROLL-OVER PROTECTION SYSTEM (ROPS)
This manual contains assembly, operating, maintenance and safety instructions for your
ROPS. Before Installing the ROPS or operating a machine equipped with a ROPS,
carefully read these instructions completely. The ROPS will reduce the risk of serious or
fatal injury in the unlikely event of a tip over although the system cannot protect the
operator from all possible injuries. By following the operating, maintenance, and safety
instructions, you will prolong the life of the machine and the ROPS, maintain its maximum
efficiency and promote safe operation.
If additional information is needed, contact your authorized equipment dealer or distributor.
Keep this manual with the machine operator’s manual for future reference.
IMPORTANT:
1. Do not cut, drill, modify or repair ROPS in any manner.
2. Always replace a damaged ROPS.
3. Always use the seatbelt and ROPS together.
4. Frequently inspect roll bar and seat belts for damage or loose hardware.
5. Use extreme care when working close to fences, ditches, trees and on hills.
6. Check overhead clearances carefully before driving under any objects.
7. Do not leave operator’s position while unit is running.
8. Do not carry riders.
9. If ROPS is a folding ROPS, ROPS should be in the upright position and pinned
when operating the machine.
WARNING! This ROPS is certified for use on machines with a maximum gross vehicle
weight (GVW) of 2300 LBS. The GVW INCLUDES the weight of the base machine, operator,
fuel, ROPS, and other attachments and payloads. When attachments are added, causing
the GVW of the machine to be more than 2300 LBS., the ROPS may not provide adequate
protection resulting in serious injury or death. Use caution when installing attachments and
DO NOT EXCEED the GVW rating of the ROPS.
WARNING!
SERIOUS INJURY OR DEATH MAY RESULT FROM
MACHINE ROLLOVER
• DO NOT OPERATE MACHINE ON STEEP SLOPES OR
NEAR DROP OFFS
• ALWAYS USE SEAT BELTS
• AVOID SHARP AND/OR QUICK TURNS
• DO NOT EXCEED THE MACHINE WEIGHT RATING OF
THE ROPS
WARNING
PRINTED IN U.S.A. FORM NO. 98210012
07/02/07
ROLLOVER MAY CAUSE PERMANENT INJURY OR DEATH.
• ROPS RAISES THE CENTER OF GRAVITY AND REDUCES STABILITY ON SLOPES.
• SUDDEN STARTS OR TURNS ON RAMPS OR SLOPES CAN CAUSE OVERTURN.
• USE GREATER CARE ON RAMPS AND AS SLOPES INCREASE.