weber 55204 - Manual (Page 21)

C-2
(2)
(1)
View from underneath
View inside of control panel
4.) While holding swing-up work surface in position,
insert the other end of the swing-up work surface
rod into the right end trim piece (1). Push the trim
piece into the frame as shown, making sure that
the tab on the back underside piece of the trim
piece is snapped into the slot in the rear frame (2).
5.) Add a washer to the bolt and insert it through the
front hole in the frame and the hole in the trim
piece. Tighten with a wrench.