Weslo 310 CS - Manual (Page 10)

10
Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild detergent. Important: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. To replace the batteries, refer
to step 4 on page 5 and remove the console from the
handlebar. Next, refer to step 3 on page 5 and insert
three batteries into the console. Reattach the console
to the handlebar, being careful not to pinch the wires.
HOW TO ADJUST THE RESISTANCE STRAP
If the resistance knob is turned to the highest setting
and there is not enough resistance, the resistance
strap may need to be adjusted. To adjust the resis-
tance strap, you must first remove the left side shield.
Using an adjustable wrench, turn the Left Pedal (24)
clockwise and remove it. Next, remove the five M4 x
25mm Screws (41) and the M4 x 16mm Screw (49)
from the Left Side Shield (17). Carefully remove the
Left Side Shield.
Next, turn the resistance knob to the lowest setting
(see HOW TO ADJUST THE PEDALING RESIS-
TANCE on page 8).
Open the Strap Clamp (3) and pull the end of the
Resistance Strap (11) slightly downward to increase
resistance. Close the Strap Clamp and turn the
Flywheel (37) to make sure there is not too much
resistance.
When the resistance strap is properly adjusted, re-
attach the left side shield and the left pedal.
MAINTENANCE AND TROUBLESHOOTING
41
49 17
41
24
3
11
37