Weider 831.15711.0 - Manual (Page 6)

6
ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Because of its weight and size, the weight bench
should be assembled in the location where it will
be used. Make sure that there is enough clear-
ance to walk around the weight bench as you
assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• For help identifying small parts, use the Part
Identification Chart.
The included grease and the following tools (not
included) may be required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Assembly Easier
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by almost anyone. However, the weight
bench has many parts and the assembly
process will take time. By setting aside plenty of
time, assembly will go smoothly.
1.
Lift the Weight Rest (7) in the Left Upright (6) and
secure it with a Weight Rest Knob (23).
Attach the Crossbar (4) to the Left Upright (6)
with a Right Joint Plate (18), a Left Joint Plate
(59), four M10 x 75mm Bolts (42), and four M10
Nylon Locknuts (43).
Do not tighten the Nylon
Locknuts yet.
Attach the Crossbar (4) to the Right Upright
(5) in the same manner.
1 Before assembling the weight bench, make
sure that that you have read and under-
stand the information in the box above.
4
5
43
43
18
18
59 59
42
6
7
23