Weslo WLEX27181 - Manual (Page 11)

11
Inspect and tighten all parts of the exercise cycle reg-
ularly. The exercise cycle can be cleaned with a soft,
damp cloth. To prevent damage to the console, keep
liquids away from the console and keep the console
out of direct sunlight.
CRANK ADJUSTMENT
If the arms of the
Crank (7) become
loose, they should
be tightened in
order to prevent
excessive wear.
Loosen the Hex
Crank Nuts (14)
on the left arm of
the Crank. Place
the tip of a stan-
dard screwdriver in one of the slots in the slotted
crank nut. Tap the screwdriver with a hammer to turn
the slotted crank nut counterclockwise until the arms
are no longer loose. Do not overtighten the slotted
crank nut. When the slotted crank nut is properly
tightened, tighten the Hex Crank Nuts.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch may need to be adjusted. To adjust the
reed switch, you must first remove the Left Side Shield
(20). Using
an adjustable
wrench, turn
the Left
Pedal (39)
clockwise
and remove
it. Next,
remove the
indicated #8
x 1/4Ó
Screws (22).
Grasp both
Side Shields
and gently
pull them apart. Turn the left arm of the Crank (7) to
the position shown, and then carefully slide the Left
Side Shield forward and remove it.
With the left side shield removed, locate the Reed
Switch (42) (see the drawing below). Turn the Crank
(7) until the Magnet (61) is aligned with the Reed
Switch. Loosen but do not remove the #8 x 1/2Ó
Screw (43). Slide the Reed Switch slightly closer to or
away from the Magnet. Retighten the Screw. Turn the
Crank for a moment. Repeat until the console dis-
plays correct feedback. When the Reed Switch is cor-
rectly adjusted, reattach the left side shield and the
left pedal.
BATTERY REPLACEMENT
If the console does not function properly, the batteries
should be replaced. See assembly step 4 on page 6.
MAINTENANCE AND STORAGE
14
Slotted
Crank Nut
7
42 61
43
7
22
20 39 7
View from the Front