Waterpik Technologies JANDY RAY-VAC H0555100 - Manual (Page 5)

Water Pik Technologies, Inc.
6. If the pump(s) is on: put your hand over the hole
in the back of the cleaner and force the water
back into the cleaner. Use the whip hose to further
remove any debris.
7. If the pump(s) is off: use a garden hose to remove
debris.
8. Make sure all moving parts are free of debris.
Install the screen and debris compartment. Place
the Ray-Vac back into the pool.
SECTION 4.
Skimmer Guard
4A. Skimmer Guard Installation
1. Insert the Skimmer Guard into the center of the
skimmer opening about 1" from the wall edge.
2. Begin turning the top half of the skimmer guard
clockwise while holding the bottom half until you
see the guard expanding in length.
3. Continue turning until the guard expands to fit
tightly between the top and bottom of the
skimmer opening.
Page 3
SECTION 5.
Remove Ray-Vac Hose from Pool
Wall
5A. Quick Disconnect
1. At the equipment pad, turn off all pool pumps.
2. Grasp the Quick Disconnect Coupler and turn it
counterclockwise ¼ turn.
3. Pull out and remove hoses from pool.
4. To reinstall, align tabs on Quick Disconnect
Coupler in the Wall Reducer.
5. To lock, turn the Quick Disconnect Coupler ¼
turn clockwise, then give a gentle pull on the hose
to seat the Quick Disconnect Coupler.
Figure 5. Check Debris Compartment Door
Figure 6. Skimmer Guard
Skimmer
Opening
Skimmer
Guard
Figure 7. Remove Quick Disconnect