Wybron Transition Optic - Manual (Page 13)

13
Display Messages
Normal Messages
680 Displayed for 1 second after power is applied. This is the RDM
manufacturer device identification number
Ini Indicates that the unit is initializing the diachronic filters
001 – 508 The first DMX address Transition will respond to.
Adr Top menu item. Pressing ‘Enter’ here will allow the current
DMX address to be changed.
DEn Top menu item. Pressing ‘Enter’ here will allow the current
DMX control/ Demo control state to be changed.
OFF Demo modes are off. Transition will respond to DMX
commands.
d1 Transition will execute demo loop 1 commands.
d2 Transition will execute demo loop 2 commands.
Blank Unit is running, nor error conditions exist, and it has been
longer than 60 seconds since the last button press.
Error Messages (Flashing)
Er1 Indicates motor 1 has encountered an error and stopped
moving.
Er2 Indicates motor 1 has encountered an error and stopped
moving.
Er3 Indicates motor 1 has encountered an error and stopped
moving.
Er4 Indicates motor 1 has encountered an error and stopped
moving.
Lo DC Supply voltage dropped below 17 volts. The unit will stop
operation at 16 volts.