beautypg.com

Weed Eater 96024000100 User Manual

Page 22

background image

22

TO ADJUST BRAKE

Your riding mower is equipped with an

adjustable brake system which is mounted

on the right side of the transaxle. If riding

mower requires more than (4) feet stop-

ping distance in highest gear on a lever dry

concrete or paved surface, then brake must

be adjusted.

1. Park riding mower on a level surface.

2. Release brake/parking pedal.

3. Measure distance between rotor and

brake pad if distance between rotor and

brake pad is more than .02" gap brake

needs to be adjusted.

4. Tighten caliper nut until .02" gap is

reached.

TO ADJUST STEERING WHEEL

ALIGNMENT
If steering wheel crossbars are not horizontal

(left to right) when wheels are positioned

straight forward, move steering wheel

and reassemble per instructions in the

"INSTALL STEERING COLUMN"section of

this manual.
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL

1. Block up front axle securely.

2. Remove dust cover, retaining ring, and

washer to allow wheel removal.

3. Repair tire and reassemble.

4. Replace washer and retaining ring

securely in axle groove.

NOTE: To seal tire punctures and prevent

flat tires due to slow leaks, purchase and

use tire sealant. Tire sealant also prevents

tire dry rot and corrosion.

Retaining

Ring

Dust

Cover

Washer

Square Key

(rear wheel only)

Rotor

Nut

Brake

Pad

NOTE: Feeler gauge may be necessary to

get correct measurement.

REAR WHEEL

1. Block up Rear axle securely.

2. Remove dust cover, retaining ring, wash-

er, and square key while pulling tire off.

3. Repair tire and reassemble.

4. Replace square key while putting tire back

on, then replace washer and retaining ring

securely in axle groove ,when pushing

tire back onto shaft reach under and pull

chain sprocket toward you to ease tire

replacement.

TO START ENGINE WITH A WEAK
BATTERY

CAUTION: Lead-acid batteries gener-

ate explosive gases. Keep sparks, flame

and smoking materials away from batteries.

Always wear eye protection when around

batteries.

If your battery is too weak to start the engine,

it should be recharged. (See "BATTERY" in

the Maintenance section of this manual).
NOTE: This unit is equipped with an engine

recoil starting system that can be used if the

battery is too weak to start. See “RECOIL

STARTING SYSTEM” in operation section

of this manual.

REPLACING BATTERY

WARNING: Do not short battery termi-

nals by allowing a wrench or any other object

to contact both terminals at the same time.

Before connecting battery, remove metal

bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected

first to prevent sparking from accidental

grounding.

This manual is related to the following products: