beautypg.com

Weider WESY68633 User Manual

Page 16

background image

16

67

ATTACHING THE ACCESSORIES

To attach a Short Handle (67) to a high pulley, first

attach the high pulley to the resistance system (see

ATTACHING THE HIGH PULLEYS on page 13). Then,

attach the Short Handle to the Short Cable (60) with a

Cable Clip (64).

The Long Handles (not shown) and the Ankle Strap

(not shown) can be attached to the long cable (not

shown) with Cable Clips (64). Attach the Leg Press

Strap (not shown) to both ends of the long cable, or the

Lat Bar (not shown) to the Short Cables (60), with two

Cable Clips.

60

60

64

32

Hook

C

62

64

53

+ / – Switch

ATTACHING THE LEG LEVER

To use the Leg Lever (32), attach the two ends of the

Leg Lever Cable (62) to the ends of the long cable (C)

with two Cable Clips (64).

Detach the Leg Lever Cable (62) from the long cable

(C) when the Leg Lever (32) is not in use. Store the

ends of the Leg Lever Cable on the hook under the

Bench Rail (23).

ADJUSTING THE RESISTANCE

To change the resistance setting, press the + / –

switch on the Console (53). The display will show the

current resistance level setting. The resistance can be

increased up to 240 pounds.

Note: While the resistance setting is changing, the

motor will be heard. To prevent damage to the

motor, do not pull any of the cables while the

resistance setting is changing.

Note: The resistance system uses progressive resist-

ance. As the resistance bar begins to bend, the

amount of resistance will increase gradually. As the

bar bends further, the resistance will increase rapidly.