Whynter T-1A - Manual (Page 10)

T-1 Version 08/05 10
Problems and Malfunctions
If the indicator light on WATERTANK is illuminated red or red/orange the water
tank level is low and requires topping up.
If the L and START indicator lights flash and the appliance beep then the Ice
Cube Drawer is not positioned properly. Remove the drawer and replace it in its
recess. There are a number of sensors associated with the Ice Cube Drawer and
the Water Tank and faulty positioning of these units is the most common cause
of malfunction. Always ensure that the Ice Cube Drawer and the Water Tank are
correctly positioned in their recesses.
If the M indicator is illuminated and the appliance beeps, or the M indicator is
flashing and the appliance is not beeping, the ice cube production process is
stuck. It may be that ice cubes are stuck to the freezer element, an ice cube is
stuck in the mechanism or the ice cubes have fused into one large block of ice. If
this happens switch off the appliance, unplug it from the mains supply, open the
cover and leave it open until all ice blockages melt. Once everything has melted
close the cover, plug the appliance in to the supply, switch on and press START.
In the event of any appliance stoppages, malfunctions or indicator light
sequences not already covered in these instructions switch the appliance off for
one minute and then switch it on again. This should clear any spurious faults.
For any faults which cannot be cleared and for further assistance and service the
contact information is shown on the last page.